| 1. Insert the Male Connector of the bottom Upright Pole into the Female Connector of the Foot assembly and turn clockwise to secure. Repeat the process for both Upright Poles. To Identify - the bottom Upright Pole has a Male and Female Connector on either side. | 2. Slide the Cross Bar onto the bottom Link Assembly of both Upright Poles. |
| 
|
| 3. Connect the top Upright Poles to the bottom assembly by means of the Connectors. To Identify - the top Upright Pole has a Female Connector on one side and an End Cap on the other | 4. Slide the Cross Bar onto the top Link Assembly of the Upright Poles |
| 
|
| 5. Ensure that the TRIGA devices are not activated/extended. Insert the Graphic Rails – top and bottom – by sliding the plastic insert into the opening on top of the TRIGA device. These inserts have been designed to locate in one direction only | 6. Insert the leading edge of the graphic panel into the Graphic Rail channel on the top assembly. Allow the print to hang freely and then insert the bottom leading edge of the panel into the bottom Graphic Rail. You will note that the there is no tension on the graphics. |
 | 
|
| 7. Press the button, through the graphic panel, to activate the self-tensioning TRIGA device. You will hear a distinct ‘bang’ sound, which will indicate that the TRIGA have been fired. The graphics will be tensioned accordingly. Fire the TRIGA’s on both the top and bottom assemblies to ensure the correct tension. |
